Switching the windshield wipers on/off
WARNING
Wiper blades are components that are subject
to wear and tear. Replace the wiper blades
twice a year, preferably in the spring and fall.
Otherwise the windshield will not be wiped
properly. As a result, you may not be able to
observe surrounding traffic conditions and
could cause an accident.
Do not operate the windshield
wipers
when the windshield is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windshield can
scratch the glass if wiping takes place when
the windshield is dry.
If the windshield wipers leave
smears on
the windshield after the vehicle has been
washed in an automatic car wash, wax or
other residues may be the reason for this.
Clean the windshield using washer fluid
after washing the vehicle in an automatic
car wash.
Combination switch
1 Windshield wipers off
2 Intermittent wipe, low
3 Intermittent wipe, high
4 Continuous wipe, slow
5 Continuous wipe, fast
6 Single
wipe/
To wipe the windshield using
washer fluid
Switch on the ignition.
Turn the combination switch to the
corresponding position.
Intermittent wiping with rain
sensor: due
to optical influences and the windshield
becoming dirty in dry weather conditions,
the windshield wipers may be activated
inadvertently. This could then damage the
windshield wiper blades or scratch the
windshield.
For this reason, you should always switch
off the windshield wipers in dry weather.
In the or
position, the appropriate
wiping frequency is set automatically
according to the intensity of the rain. In
the
position, the rain sensor is
more
sensitive than in the
position,
causing
the windshield wipers to wipe more
frequently.
See also:
Folding the seat backrest back
•► Move the driver's or front-passenger seat
forward if necessary.
! Make sure that the seat belt does not
become trapped when folding the rear seat
backrest back. Otherwise, it could b ...
Setting the rear-compartment airflow
using the rear control panel
Turn the SmartKey to position 2 in the
ignition lock.
To increase/reduce: press rocker switch
14 up or down. ...
Deactivating/activating ESP®
WARNING
Under no circumstances should you
deactivate ESP® when the ESP®
warning lamp in the instrument cluster
flashes. Proceed as follows:
• when driving off, apply as little throttle as p ...