Lowering the vehicle

until the vehicle is once again Turn the crank of the jack counterclockwise until the vehicle is once again standing firmly on the ground.

Place the jack to one side.

Tighten the wheel bolts evenly in a

crosswise pattern in the sequence Tighten the wheel bolts evenly in a crosswise pattern in the sequence indicated (1 to 5). The tightening torque must be 110 lb-ft (150 Nm).

store it together with the rest of the tirechange Turn the jack back to its initial position and store it together with the rest of the tirechange tool kit in the stowage well under the trunk floor.

spare wheel mounted, the tire pressure When you are driving with the emergency spare wheel mounted, the tire pressure monitoring system cannot function reliably. Only restart the tire pressure monitoring system when the defective wheel has been replaced with a new wheel.
All mounted wheels must be equipped with functioning sensors and the defective wheel should no longer be in the vehicle.

    See also:

    Exterior mirror out of position
    If an exterior mirror has been pushed out of position, proceed as follows: Press the mirror-folding button repeatedly until you hear the mirrors engage in position. The mirror housing is ...

    Low outside temperatures
    DEF freezes at a temperature of approximately 12 °F (–11 °C). The vehicle is equipped with a DEF preheating system when it leaves the factory. Winter operation is therefore also guaranteed at ...

    Vehicle remote closing
    If you forget to lock your vehicle but are no longer in the vicinity of the vehicle, it can be locked for you by the Mercedes-Benz Customer Assistance Center. The vehicle can be locked remotely ...