Fuse box under the rear bench seat
– Fold the right-hand rear bench seat forward.
– To open: lift and fold back carpet 1 in the direction of the arrow.
– Release clamps 2 by pressing them in the
direction of the arrow.
– Fold cover 3 up in the direction of the
arrow and remove it.
Make sure that no moisture can enter the fuse box when the cover is open.
The fuse allocation chart is located under cover 3.
– To close: insert cover 3 at the side of the
fuse box into the retainers.
– Fold down cover 3 until clamps 2 engage
audibly.
– Fold the right-hand rear bench seat back.
See also:
Important safety notes
WARNING
It is dangerous to shift the automatic
transmission out of parking position P or
neutral position N if the engine speed is
higher than idle speed. If your foot is not firmly
on the ...
Avoiding a section of the route blocked
by a traffic jam
This function blocks a section of the route
ahead of you. You can set the length of the
blocked route section. If possible, COMAND
calculates a detour around the blocked
section of the route.
...
Please bear the following in mind
Resetting service interval display
If the qualified specialist workshop, e.g. a
Mercedes-Benz Center, carried out the
maintenance work, the service interval
display will be reset.
Further info ...