Tire pressure of at least 180 kPa (1.8 bar/26 psi) is not reached

Mercedes-Benz M-Class / Mercedes-Benz M-Class Owners Manual / Breakdown assistance / Flat tire / TIREFIT kit / Tire pressure of at least 180 kPa (1.8 bar/26 psi) is not reached

If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved:
– Switch off the tire inflation compressor.
– Unscrew the filler hose from the valve of the faulty tire.
– Very slowly drive forwards or reverse approximately 30 ft (10 m).
– Pump up the tire again.

If after five minutes a pressure of 180 kPa WARNING
If after five minutes a pressure of 180 kPa (1.8 bar/26 psi) cannot be achieved, the tire is too badly damaged to be repaired reliably using TIREFIT.
In this case TIREFIT cannot seal the tire properly.
Do not drive any further.
Contact the nearest authorized Mercedes- Benz Center for assistance or call Roadside Assistance.

    See also:

    Problems with the engine
    Problem Possible causes/consequences and Solutions The engine does not start. The starter motor can be heard. • There is a malfunction in the engine electronics. • Th ...

    Vehicle tool kit
    The vehicle tool kit can be found in the stowage well under the trunk floor/cargo compartment floor. Depending on the vehicle equipment, the vehicle tool kit is on the lefthand side or the rig ...

    Warning displays
    The warning displays show the distance between the sensors and the obstacle. The warning display for the front area is located on the dashboard above the center air vents. The warning display fo ...