Setting and storing the parking position
You can position the front-passenger side exterior mirror in such a way that you can see the rear wheel on that side as soon as you engage reverse gear. You can store this position.
- Make sure that the vehicle is stationary and
that the SmartKey is in position 2 in the
ignition lock.
- Engage reverse gear.
The exterior mirror on the front-passenger
side moves to the preset parking position.
- Use adjustment button 3 to adjust the
exterior mirror to a position that allows you
to see the rear wheel and the curb.
The parking position is stored.
If you shift the transmission to
another
position, the exterior mirror on the frontpassenger
side returns to the driving
position.
You can also store the parking
position
using memory button M 4.
- Make sure that the SmartKey is in
position 2 in the ignition lock.
- With the exterior mirror on the frontpassenger
side activated, use
adjustment button 3 to adjust the
exterior mirror to a position which
allows you to see the rear wheel and
the curb.
- Press memory button M 4 and one of
the arrows on adjustment button 3
within three seconds.
The parking position is stored if the
exterior mirror does not move.
If the mirror moves out of position, repeat the steps.
See also:
Belt warning for the driver and front
passenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the seat belt warning lamp
lights up for 6 seconds after every engine
start. It then goes out if t ...
Jump-starting
WARNING
Failure to follow these directions will cause damage to the electronic
components, and can lead
to a battery explosion and severe injury or death.
Never lean over batteries while connec ...
Information about driving abroad
Converting to symmetrical low beam
when driving abroad: switch the headlamps
to symmetrical low beam in countries in
which traffic drives on the opposite side of the
road to the country where ...