NECK-PRO head restraints

restraints Resetting the NECK-PRO head restraints requires a lot of strength. If you have difficulty resetting the NECK-PRO head restraints, have this work carried out at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.

Tilt the top of the NECK-PRO

head restraint Tilt the top of the NECK-PRO head restraint cushion forwards in the direction of arrow 1.

cushion Push the NECK-PRO head restraint cushion down in the direction of arrow 2 as far as it will go.

restraint Firmly push the NECK-PRO head restraint cushion back in the direction of arrow 3 until the cushion engages.

second Repeat this procedure for the second NECK-PRO head restraint.

    See also:

    Windshield/headlamp cleaning system
    WARNING Washer solvent/antifreeze is highly flammable. Do not spill washer solvent/antifreeze on hot engine parts, because it may ignite and burn. You could be seriously burned. Use MB Sum ...

    Ashtray in the rear-compartment center console
    To open: pull cover 2 out by its top edge. To remove the insert: press release button 3 and lift the insert up and out. To install the insert: install insert 1 from above into the holder a ...

    Windshield washer system andheadlamp cleaning system
    The washer fluid reservoir is used for both the windshield washer system and the headlamp cleaning system. Vehicle components and their service products must match. You should, therefore, only ...