Opening/closing the garage door

Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

► Turn the SmartKey to position 2 in the ignition lock.
► Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.

Garage door system with a fixed code:

indicator lamp 1 lights up green.

Garage door system with a rolling code:

indicator lamp 1 flashes green.

as long as the transmitter button is being The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.

    See also:

    Activating/deactivating the MONOfunction
    The MONO function is only available with automatic climate control.18 You can use the MONO function to adopt the settings configured for temperature, air distribution and airflow on the driver's s ...

    Please bear the following in mind
    For safety reasons, Mercedes-Benz recommends that you only use Tires and wheels which have been approved by Mercedes-Benz specifically for your vehicle. These tires have been specially adapted f ...

    Interchanging the wheels
    WARNING Rotate front and rear wheels only if the tires are of the same dimension. If your vehicle is equipped with mixed-size tires (different tire dimensions front vs. rear), tire rotation ...