Preparing the cargo net

The cargo net can be used in two different positions (behind the B-pillar or the C-pillar).

• The brackets behind B-pillar : are

The brackets behind B-pillar : are required for the cargo compartment enlargement.

The corresponding cargo tie down rings to tighten the net are located in the footwell of the rear bench seat.

The brackets behind C-pillar ; are required for the cargo compartment behind the 2nd row of seats.

The corresponding cargo tie down rings for tensioning the net are in the cargo compartment or on the backrests of the folded-down 3rd row of seats.

Undo the two Velcro fasteners of the safety-net stowage.
Unroll and unfold the cargo net.

The upper and lower guide rods must engage audibly.

    See also:

    General notes
    USA only: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device mus ...

    Service and literature
    Your vehicle is covered under the terms of the warranties printed in the Service and Warranty Information booklet. Your authorized Mercedes-Benz Center will exchange or repair any defective pa ...

    Important safety notes
    WARNING For safety reasons, switch off the windshield wipers and remove the key from the ignition lock before changing the wiper blades (vehicles with KEYLESS-GO: make sure that the on-board ...