Activating/deactivating the residualheat function

It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.

regardless of the airflow setting. The blower will run at a low speed regardless of the airflow setting.

at high temperatures, only the ventilation If you activate the residual heat function at high temperatures, only the ventilation will be activated. The blower runs at medium speed.

► Turn the SmartKey to position 0 in the ignition lock or remove it.
► To activate: press thebutton. button.

The indicator lamp in the lights button lights up.

► To switch off: press the button.

The indicator lamp in the goes button goes out.

automatically: Residual heat is deactivated automatically:

• after about 30 minutes
• when the ignition is switched on
• if the battery voltage drops
• if the coolant temperature is too low

    See also:

    Introduction
    In transmission position D, you can use the steering wheel paddle shifter to restrict or derestrict the shift range for the automatic transmission (Y page 147). The shift range selected is show ...

    Function restrictions
    You will not be able to use the telephone, will no longer be able to use the telephone, or you may have to wait before using it, in the following situations: • when the mobile phone is switch ...

    Important safety notes
    WARNING   It is dangerous to shift the automatic transmission out of parking position P or neutral position N if the engine speed is higher than idle speed. If your foot is not firmly o ...