Notes on using 3-zone automaticclimate control

The following contains instructions and recommendations to enable you to get the most out of your automatic climate control.

• Activate climate control using the buttons. The indicator lamps in the and and buttons. The indicator lamps in the buttons light up. and • Set the temperature to 72 °F (22 °C). buttons light up.
• Set the temperature to 72 °F (22 °C).
• Only use the "defrosting" function briefly until the windshield is clear again.
• Only use "air-recirculation" mode briefly, e.g. if there are unpleasant outside odors or when in a tunnel. The windows could otherwise fog up as, in air-recirculation mode, no fresh air is drawn into the vehicle.
• Use the MONO function if you want to adopt the temperature and air distribution settings from the driver's side for all climate zones. The indicator lamp in the • Use the residual heat function if you want button lights up.
• Use the residual heat function if you want to heat or ventilate the vehicle interior when the ignition is switched off. The "residual heat" function can only be activated or deactivated with the ignition switched off.

    See also:

    Important safety notes
    The coolant is a mixture of water and antifreeze/corrosion inhibitor. It performs the following tasks: • corrosion protection • antifreeze protection • raising the boiling point The engi ...

    ATA (Anti-Theft Alarm system)
    A visual and audible alarm is triggered if the alarm system is armed and you open: • a door • the vehicle with the mechanical key • the trunk lid • the hood The alarm is not switched off, even ...

    Trip computer "From start" or "From reset
    The values in the From Start submenu are calculated from the start of a journey, while the values in the From Reset submenu are calculated from the last time the submenu was reset. Press the ...