Preparing the vehicle
- Stop the vehicle as far away as possible from traffic on solid, non-slippery and level ground.
- Switch on the hazard warning lamps.
- Firmly depress the parking brake.
- Bring the front wheels into the straightahead position.
- Move the selector lever to P.
- Switch off the engine.
- Vehicles without KEYLESS-GO: remove the SmartKey from the ignition lock.
- Vehicles with KEYLESS-GO: open the driver's door. The on-board electronics have status 0, which is the same as the SmartKey having been removed.
- Vehicles with KEYLESS-GO: remove the Start/Stop button from the ignition lock ().
- All occupants must get out of the vehicle. Make sure that they are not endangered as they do so.
- Make sure that no one is near the danger area while a wheel is being changed. Anyone who is not directly assisting in the wheel change should, for example, stand behind the barrier.
- Get out of the vehicle. Pay attention to traffic conditions when doing so.
- Close the driver's door.
See also:
Adjusting the volume
Adjusting the volume for the audio or
video source
Adjusting the volume for the audio or video source
To adjust: turn thumbwheel 1.
or
Press the or
button on the
multifunction steer ...
Kickdown
Use kickdown for maximum acceleration.
- Vehicles for USA: fully depress the
accelerator pedal.
The transmission shifts to a lower gear
depending on the engine speed.
- Vehicles for Canada: dep ...
Switching on/off
The three blue indicator lamps in the buttons
indicate the ventilation level you have
selected.
If the battery voltage is too low, the seat
ventilation may switch off.
Make sure that the S ...