Setting the compass
- Determine your position using the following zone maps.
North America zone map
South America zone map
- Press a round pin into opening 3() for approximately three seconds. The currently selected zone appears in compass display 2().
- To select the zone: press a round pin into opening 3() repeatedly until the desired zone is selected. The zone has been selected when compass display 2() shows the heading. This takes a few seconds.
See also:
Automatic engine start
The engine is started automatically if you:
• release the brake pedal when HOLD is not
activated and the transmission is in
position D or N
• shift the transmission to position R
• depres ...
Wake up: ATTENTION ASSIST issues warning on detecting drowsiness
Studies have shown that around a quarter of all serious motorway accidents
are caused by drowsy drivers, making this factor an even bigger cause of
accidents than drink-driving. With ATTENTION ASS ...
Incoming call
Rejecting or accepting a call
When there is an incoming call, you see a
corresponding window in the display.
To reject: select Reject by turning
the COMAND controller and press to
confir ...