Seat belt adjustment
The seat-belt adjustment function adjusts the driver's and front-passenger seat belt to the upper body of the occupants.
The belt strap is tightened slightly when:
• you engage the belt tongue in the belt
buckle and you then turn the SmartKey to
position 2 in the ignition lock.
• the SmartKey is in position 2 in the
ignition
lock and you then engage the belt tongue
in the buckle.
The seat-belt adjustment will apply a retraction force if any slack is detected between the occupant and the seat belt. Do not hold on to the seat belt tightly while it is adjusting. You can switch the seat-belt adjustment on and off in the on-board computer.
The seat-belt adjustment is an integral part of the PRE-SAFE® convenience function. More information about PRE-SAFE® can be found in the "PRE-SAFE® (preventative occupant protection)" section.
See also:
Attaching the combined cargo cover
and net to the rear seat backrest
•► Fold the left and right seat backrest
forwards
•► Insert combined cargo cover and net 2
into the two guides 1 and push it up to the
stop in the direction of the arrow.
! If yo ...
Snow chains
For safety reasons, Mercedes-Benz
recommends that you only use snow chains
which have been specially approved for your
vehicle by Mercedes-Benz, or are of a
corresponding standard of quality.
...
Adaptive Highbeam Assist
You can use this function to set the
headlamps to change between low beam and
high beam automatically. The system
recognizes vehicles with their lights on, either
approaching from the opposite ...