Opening/closing the garage door
Once programmed, the integrated remote control will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
X Turn the SmartKey to position 2 in the ignition lock.
X Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door. Garage door system with fixed code: indicator lamp 1 lights up continuously.
Garage door system with rolling code: indicator lamp 1 flashes briefly and then lights up for approximately two seconds. This is repeated for up to 20 seconds.
The transmitter will transmit a signal for as long as the transmitter button
is being pressed. The transmission will be halted after a maximum of 20 seconds
and indicator lamp 1 will flash. Press the transmitter button again, if necessary.
See also:
Radiator
Vehicles with a diesel engine: do not
cover the radiator, for example with a
winter front or bug cover. Otherwise, the
readings of the on-board-diagnostic
system may be inaccurate. Some of these
...
Activating/deactivating Lane Keeping
Assist
You can use the Lane Keep. Asst. function
to activate/deactivate Lane Keeping Assist
(Y page 200) or Active Lane Keeping Assist.
– Press the or
button on the
steering wheel to select the Dri ...
Cleaning the plastic trim
WARNING
When cleaning the steering wheel boss and
dashboard, do not use cockpit sprays or
cleaning agents containing solvents. Cleaning
agents containing solvents cause the surface
to become ...