Activating the rear view camera

  • Make sure that the SmartKey is in position 2 in the ignition lock.
  • Make sure that the "rear view camera" function is selected in COMAND (see the separate operating instructions for COMAND).
  • Engage reverse gear. The area behind the vehicle is shown in the COMAND display with guide lines.
    See also:

    Using the rear center seat belt
    If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt: pull out ...

    Hill start assist
    Hill start assist helps you when pulling away forwards or in reverse on an uphill gradient. It holds the vehicle for a short time after you have removed your foot from the brake pedal. This gives ...

    Mounting a new wheel
    WARNING Always replace wheel bolts that are damaged or rusted. Never apply oil or grease to wheel bolts. Damaged wheel hub threads should be repaired immediately. Do not continue to dri ...