Parking lamp/standing lamp
- Switch off the lights.
- Open the hood.
- Remove the headlamp cover ().
- Left-hand headlamp: detach the washer fluid reservoir ().
- Turn housing cover 1 counter-clockwise and pull it out.
- Pull out bulb holder 2.
- Take the bulb out of bulb holder 2.
- Insert the new bulb into bulb holder 2.
- Insert bulb holder 2.
- Align housing cover 1 and turn it clockwise until it engages.
- Left-hand headlamp: fasten the washer fluid reservoir ().
- Install the headlamp cover ().
See also:
Setting the rear-compartment air
vents
Setting the center vents in the rear
compartment
1. Rear-compartment air vent thumbwheel
2. Rear-compartment air vent, right
3. Rear control panel for automatic climate
control
4. R ...
Parking brake
If you drive on wet roads or dirt-covered surfaces, road salt and/or dirt could
get into the parking brake.
In order to prevent corrosion and a reduction in the braking power of the parking
brake ...
Components and storage
The EASY-PACK load-securing kit allows you
to use your cargo compartment for a variety
of purposes. The accessory parts are located
under the trunk floor.
– Open the trunk floor.
EASY-PACK ...