Snow chains
For safety reasons, Mercedes-Benz recommends that you only use snow chains which have been specially approved for your vehicle by Mercedes-Benz, or are of a corresponding standard of quality.
You must drive at raised vehicle level if
snow chains have been mounted. The
vehicle could otherwise be damaged.
There is not enough space for snow
chains on some wheel sizes. Observe the
information under "Tires and wheels" in the
"Technical Data" section to avoid damage
to the vehicle or the wheels.
• Only use snow chains when driving on roads completely covered by snow. Do not exceed the maximum permissible speed of 30 mph (50 km/h). Remove the snow chains as soon as possible when you are no longer driving on snow-covered roads.
• Local regulations may restrict the use of snow chains. Applicable regulations must be observed if you wish to mount snow chains.
• Snow chains must not be mounted on emergency spare wheels.
If you intend to mount snow chains, please bear the following points in mind:
• you may not attach snow chains to all wheel-tire combinations; see the information under "Wheel and tire combinations" in the "Wheels and tires" section.
• mount snow chains only in pairs and only to the rear wheels. Observe the manufacturer's installation instructions.
If snow chains are mounted on the front
wheels, the snow chains could grind
against the bodywork or components of the
chassis. This could result in damage to the
vehicle or the tires.
Vehicles with steel wheels: if you wish
to mount snow chains on steel wheels,
make sure that you remove the respective
wheels' hubcaps first. The hubcaps may
otherwise be damaged.
You may wish to deactivate
ESP® when pulling away with
snow chains mounted. This way you can
allow the wheels to spin in a controlled
manner, achieving an increased driving
force (cutting action).
See also:
Seat belt
Problem
Possible causes/consequences and
Solutions
After
starting the engine, the red seat belt warning lamp lights up for six
seconds.
The seat belt warning lamp re ...
Selecting a station
Selecting a station using the station
search function
Turn or slide
the COMAND
controller while the display/selection
window in the radio display is active.
Station search scans up or down ...
Pedals
WARNING
Make sure absolutely no objects are
obstructing the pedals' range of movement.
Keep the driver's footwell clear of all
obstacles. If there are any floormats or
carpets in the footw ...
