Switching the city model on/off

When the city model is switched on, the map shows buildings as 3D models.

map" map orientation. The city model is only shown in the "3D map" map orientation.
It is available for map scales 50 m and 100 m.
The data required for displaying buildings is not available for all cities.

the COMAND To show the menu: press the COMAND the COMAND controller.

sliding and turning Select Navi in the main function bar by sliding the COMAND and turning the COMAND the COMAND controller and press Select City (3D) and press to confirm.

to confirm. Select City (3D) and press to confirm. to confirm.

Depending on the previous state, switch the option on . or off .

1 Hills

1 Hills
2 Buildings
3 Important buildings

    See also:

    Using the rear center seat belt
    If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt: pull out ...

    Windshield washer system andheadlamp cleaning system
    The washer fluid reservoir is used for both the windshield washer system and the headlamp cleaning system. Vehicle components and their service products must match. You should, therefore, only ...

    Defrosting the windows
    Windows fogged up on the inside ► Activate the cooling with air dehumidification function . ► Activate automatic mode . ► If the windows continue to fog up, activate the defr ...