Introduction
COMAND automatically stores the previous destinations for which the route calculation has been started. If the memory is full, COMAND deletes the oldest destination. You can also save a destination from the list of previous destinations in the destination memory. It will be stored there permanently.
See also:
Cleaning the seat belts
Use clean, lukewarm water and soap solution.
Do not clean the seat belts using chemical cleaning agents. Do not dry the
seat belts by warming them above 176 ‡ (80 †) or placing them in dire ...
Towing and tow-starting
WARNING
If you tow the vehicle, you must use a rigid
towing bar if:
• the engine is not running.
• there is a brake system malfunction.
• there is a malfunction in the power supply or the vehi ...
Problems with the seat heating
The seat heating has switched off prematurely or cannot be switched on. The vehicle's
electrical system voltage is too low because too many electrical consumers are switched
on.
X Switch off ...