General information
If COMAND is equipped with a navigation system and has GPS reception, COMAND automatically sets the time and date. You can also adjust the time yourself in 30-minute increments, but the date cannot be changed.
If you set the time in 30-minute
increments, any time zone settings and
settings for changing between summer and
standard time are lost.
The following navigation system functions
require the time, time zone and summer/standard time to be set correctly in
order
to work properly:
• route guidance on routes with timedependent traffic guidance
• calculation of expected time of arrival
See also:
Warning and display messages in the
multifunction display
Activate ATTENTION ASSIST using the onboard
computer.
Symbol 1 appears in the multifunction
display.
If ATTENTION ASSIST is active, you will be
warned no sooner than 20 minutes after your
...
Problems with the seat ventilation
The seat ventilation has switched off
prematurely or cannot be switched on. The
vehicle's electrical system voltage is too low
because too many electrical consumers are
switched on.
Switch o ...
Coolant
Important safety notes
The coolant is a mixture of water and
antifreeze/corrosion inhibitor. It performs
the following tasks:
- corrosion protection
- antifreeze protection
& ...