Activating RACE START
•► Depress the brake pedal with your left foot, and keep it depressed.
•► Turn the drive program selector clockwise until the RS lamp lights up.
The multifunction display shows the RACE START Confirm: Paddle UP Cancel:
Paddle DOWN message
If the conditions for activation are no longer fulfilled, RACE START is canceled.
The multifunction display shows the RACE START canceled message.
•► To cancel: pull the left steering wheel shift
paddle
or
•► To confirm: pull the right steering wheel
shift paddle.
The multifunction display shows the RACE START available Depress accelerator message.
If you do not depress the accelerator pedal fully within two seconds, RACE START is canceled. The multifunction display shows the RACE START not possible See Operator's Manual message.
•► Depress the accelerator pedal fully.
The engine speed increases to approximately 4000 rpm.
The multifunction display shows the RACE START Release brake to start message.
If you do not release the brake pedal within seven seconds, RACE START is canceled. The multifunction display shows the RACE START canceled message.
Take your foot off the brake, but keep the accelerator pedal depressed.
The vehicle pulls away at maximum acceleration.
The multifunction display shows the RACE START active message.
RACE START is deactivated when a speed of approximately 30 mph (Canada: 50 km/h) is reached. Drive program S+ is activated.
SPORT handling mode remains activated.
RACE START is deactivated immediately if you release the accelerator pedal during RACE START or if any of the activation conditions are no longer fulfilled. The multifunction display shows the RACE START not possible See Operator's Manual message
If RACE START is used repeatedly within a short period of time, it is only available again after the vehicle has been driven a certain distance.
See also:
Automatic transmission
Shift the transmission to position P.
The transmission position display in the
multifunction display shows P.
You can also start the engine when the
transmission is in position N. ...
Introduction
You can establish a Bluetooth® connection to
COMAND (see the separate operating
instructions).
WARNING
A driver's attention to the road must always
be his/her primary focus when drivi ...
Useful information
This Operator's Manual describes all models and all standard and optional equipment
of your vehicle available at the time of publication of the Operator's Manual. Country-specific
diffe ...
