Deactivating the HOLD function
The HOLD function is deactivated automatically if:
- you accelerate and the transmission is in
position D or R.
- you shift the transmission to position P.
- you apply the brakes again with a certain
amount of pressure until HOLD disappears
from the multifunction display.
- you activate DISTRONIC PLUS.
WARNING
Never get out of the vehicle when the HOLD
function is activated.
The HOLD function must never be operated or deactivated by a passenger or from outside the vehicle.
The HOLD function does not replace the parking brake and must not be used for parking.
The braking effect of the HOLD function is canceled and the vehicle could roll away if:
- the HOLD function is deactivated by depressing the accelerator pedal or the brake pedal.
- there is a malfunction in the system or an interruption in the power supply, e.g.
battery failure.
- the electrical system in the engine compartment, the battery or the fuses are tampered with.
- the battery is disconnected.
If you leave the vehicle or park it, deactivate the HOLD function and secure the vehicle against rolling away.
When the HOLD function is activated, the transmission is shifted automatically to position P if:
- the driver's door is open and the driver's
seat belt is unfastened.
- the engine is switched off.
- the hood is opened.
- a system malfunction occurs.
- the power supply is not sufficient.
If the engine has been switched off, it cannot be started again until the HOLD function has been deactivated.
If there is a malfunction in the system or power supply while the HOLD function is activated, the Brake immediately message is shown in the multifunction display.
Immediately depress the brake firmly until the warning message in the multifunction display goes out.
See also:
Adjusting the steering wheel electrically
1 To adjust the steering wheel height 2 To adjust the steering wheel position
(fore-and-aft adjustment)
Other topics:
EASY-ENTRY/EXIT feature ()
storing settings ()
...
The windshield wipers are obstructed
Leaves or snow, for example, may be
obstructing the windshield wiper movement.
The wiper motor has been deactivated.
For safety reasons, you should
remove the SmartKey from the ignition lock.
...
The mbrace system
The mbrace system provides different
services, e.g.:
- automatic and manual emergency call
- Roadside Assistance call
- MB Info call
To adjust the volume during an mbrace ...