Daytime running lamps
Daytime running lamps in Canada
The daytime running lamps function is required by law in Canada. It cannot therefore be deactivated.
•► Turn the light switch to or .
With the engine running: depending on the ambient light, the daytime running lamps or the low-beam headlamps are switched on.
When the low-beam headlamps are switched on, the indicator lamp in the instrument cluster lights up.
When the engine is running and the vehicle is stationary: if you move the selector lever from a drive position to P, the daytime running lamps/low-beam headlamps go out after three minutes.
When the engine is running, the vehicle is stationary and in high ambient light brightness: if you turn the light switch to , the daytime running lamps and the parking lamps are switched on.
If the engine is running and you turn the light switch to , the manual settings take precedence over the daytime running lamps.
Daytime running lamps in the USA
In the USA, the daytime running lamps are deactivated upon delivery from the factory.
•► To activate the daytime running lamps: activate the daytime running lamps function in the on-board computer
•► Turn the light switch to or .
With the engine running: depending on the ambient light, the daytime running lamps or the low-beam headlamps are switched on.
When the low-beam headlamps are switched on, the indicator lamp in the instrument cluster lights up.
If the engine is running and you turn the light switch to or , the manual settings take precedence over the daytime running lamps.
See also:
Maximum load rating
The maximum load rating in kilograms or
pounds is the maximum weight for which a
tire is approved. ...
Notes on using 3-zone automatic
climate control
The following contains instructions and
recommendations to enable you to get the
most out of your automatic climate control.
- Activate climate control using the
and
buttons. The indic ...
PSI (pounds per square inch)
A standard unit of measure for tire pressure. ...