Resetting the side windows
You must reset each side window if a side window can no longer be closed fully.
•► Close all the doors.
•► Turn the SmartKey to position 1 or 2 in the ignition lock.
•► Pull the corresponding switch on the door control panel until the side window is completely closed.
•► Hold the switch for an additional second.
If the side window opens again slightly:
•► Immediately pull the corresponding switch on the door control panel until the side window is completely closed.
•► Hold the switch for an additional second.
•► If the corresponding side window remains closed after the button has been released, the side window has been reset correctly.
If this is not the case, repeat the steps above again.
See also:
Setting the map to the vehicle position,
intermediate stop or destination
position
Centering the map on the vehicle position
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller a ...
Cleaning the seat belts
•► Use clean, lukewarm water and soap
solution.
Do not clean the seat belts using chemical
cleaning agents. Do not dry the seat belts
by warming them above 176 °F (80
°C) or
placing th ...
Releasing seat belts
► Press release button 4 and
guide belt tongue 2 back towards belt
sash guide 1.
Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped i ...