Releasing seat belts
► Press release button 4 and guide belt tongue 2 back towards belt sash guide 1.
Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped in the door or in the seat
mechanism. This could damage the door,
the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill their protective function and must be replaced. Consult an authorized Mercedes- Benz Center.
See also:
Points to observe before use
The sockets can be used for accessories, e.g. lamps or mobile phone chargers
with a maximum current draw of 180 W (15 A).
If you use the sockets for long periods when the engine is switched off, th ...
Comfort system: AIRMATIC air suspension with ADS
The AIRMATIC full air suspension system including the Adaptive Damping System
ADS offers a soft basic suspension setup with a low natural frequency, where
full spring travel is available even when ...
Making adjustments in 5 mph (Canada: 10 km/h) increments
•► Briefly press the cruise control lever beyond the pressure point, up 1 for a higher speed or down 2 for a lower speed.
The last speed stored is increased or reduced. ...