Resetting triggered NECK-PRO head restraints

WARNING
For safety reasons, have the NECK-PRO head restraints checked at an authorized Mercedes-Benz Center after a rear-end collision.

WARNING
When pushing back the NECK-PRO head restraint cushion, make sure your fingers do not become caught between the head restraint cushion and the cover. Failure to observe this could result in injuries.

Resetting the NECK-PRO head restraints requires a lot of strength. If you have difficulty resetting the NECK-PRO head restraints, have this work carried out at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.

Example: Sedan

Example: Sedan

- Tilt the top of the NECK-PRO head restraint cushion forwards in the direction of arrow 1.
-  Push the NECK-PRO head restraint cushion down in the direction of arrow 2 as far as it will go.
-  Firmly push the NECK-PRO head restraint cushion back in the direction of arrow 3 until the cushion engages.
-  Repeat this procedure for the second NECK-PRO head restraint.

    See also:

    Attaching the roof carrier
    Secure the roof carrier to the roof rails. Observe the manufacturer's installation instructions. ...

    INTERIOR
    In stark contrast to the fresh, forward-thinking exterior styling, the CLS550's interior comes off as stodgy and conservative. Frankly, it's got quite the boys-club feel inside. No luxury has been ...

    Cleaning the seat belts
    ► Use clean, lukewarm water and soap solution. Do not clean the seat belts using chemical cleaning agents. Do not dry the seat belts by warming them above 176 °F (80 °C) or placing them i ...