Opening and closing

Overhead control panel
Overhead control panel

1 To open
2 To open
3 To close

1 or 2 in the ignition lock. Turn the SmartKey to position 1 or 2 in the ignition lock.

switch in the corresponding Press or pull the direction. switch in the corresponding direction.

switch beyond the If you press the point of resistance, an automatic opening/closing process is started in the switch beyond the point of resistance, an automatic opening/closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    Problems with your vehicle
    If you should experience a problem with your vehicle, particularly one that you believe may affect its safe operation, we urge you to contact an authorized Mercedes-Benz Center immediately to ...

    Load bearing index
    The load bearing index (also load index) is a code that contains the maximum load bearing capacity of a tire. ...

    Transfer case
    This section is only valid for vehicles with 4-wheel drive (4MATIC). Power is always transmitted to both axles. Performance tests may only be carried out on a 2-axle dynamometer. The brake ...