Changing the settings of the locking system
You can change the setting of the locking system in such a way that only the driver's door and the fuel filler flap are unlocked. This is useful if you frequently travel on your own.
To change the setting: press and hold down the and buttons simultaneously for approximately six seconds until the battery check lamp flashes twice.
If the setting of the locking system is changed within the signal range of the vehicle, pressing the or button locks or unlocks the vehicle.
The SmartKey now functions as follows:
To unlock the driver's door:
press the button once.
To unlock centrally: press
the button twice.
To lock centrally: press the
button.
The KEYLESS-GO function is changed as follows:
To unlock the driver's door:
touch the inner surface of the door handle on the driver's door.
To unlock centrally: touch
the inner surface of the door handle on the frontpassenger door or the rear
door.
To lock centrally: touch the
outer sensor surface on one of the door handles.
See also:
Cleaning the windows
WARNING
Before cleaning the windshield or wiper
blades, switch off the windshield wipers and
remove the SmartKey from the ignition lock.
On vehicles with KEYLESS-GO, press the
Start/Stop butt ...
Opening/closing the garage door
Once programmed, the integrated garage
door opener will assume the function of the
garage door system's remote control. Please
also read the operating instructions for the
garage door system.
...
Important safety notes
The coolant is a mixture of water and
antifreeze/corrosion inhibitor. It performs
the following tasks:
• corrosion protection
• antifreeze protection
• raising the boiling point
The engi ...