Turn signal lamps/side marker lamps
- Switch off the lights.
- Open the hood.
- Remove the headlamp cover ().
- Left-hand headlamp: detach the washer fluid reservoir ().
- Turn bulb holder 1 or 2 counterclockwise and pull it out.
- WY 5 W (turn signal lamp and side marker lamp): remove the bulb from bulb holder 1.
- PY 21 W (turn signal lamp): turn the bulb counter-clockwise, applying slight pressure, and remove it from bulb holder 2.
- WY 5 W (turn signal lamp and side marker lamp): insert the new bulb into bulb holder 1.
- PY 21 W (turn signal lamp): insert the new bulb into bulb holder 2 and turn it clockwise while applying slight pressure.
- Insert bulb holder 1 or 2 and turn it clockwise.
- Left-hand headlamp: fasten the washer fluid reservoir ().
- Install the headlamp cover ().
See also:
4ETS (Electronic Traction System)
Observe the "Important safety notes"
section.
Traction control is part of ESP®.
Traction control brakes the drive wheels
individually if they spin. This enables you to
pull away and ...
Releasing seat belts
Press release button 4() and guide belt tongue 2 back towards
belt sash guide 1.
Make sure that the seat belt is fully rolled up. Otherwise, the seat belt or
belt tongue will be trapped ...
Driving with summer tires
At temperatures below 45 °F (+7 °C), the
elasticity of summer tires and therefore also
traction and braking capability are reduced
considerably — equip your vehicle with
M+S tires. Using summe ...