Removing/installing the headlamp cover

You must remove the headlamp cover in the engine compartment before you can replace the bulbs in the headlamp.

  1. To remove: press retaining clip 1 in the direction of the arrow.
  2. Pull cover 2 forward underneath cover 3 and remove.
  3. To install: slide cover 2 under cover 3. Connect the two covers by inserting the tongue into the groove.
  4. Press cover 2 until retaining clip 1 engages.
    See also:

    Driving on sand
    WARNING Do not reduce the tire inflation pressure before driving through sand. However, if you do so, remember to correct the tire inflation pressure before continuing your trip. Driving wit ...

    Switching to MUSIC REGISTER
    Select Audio in the main function bar by sliding and turning the COMAND controller and press to confirm. If MUSIC REGISTER was the last mode selected, it is now switched on. If another au ...

    Tire pressure monitor warning messages
    If the tire pressure monitor detects a significant pressure loss on one or more tires, a warning message is shown in the multifunction display. A warning tone also sounds and the tire pressure ...