Panic alarm

- To activate: press
button
1 for at least one second.
An alarm sounds and the exterior lighting flashes. - To deactivate: press
button
1 again.
or
- Insert the SmartKey into the ignition lock.
or
- Press the KEYLESS-GO Start/Stop button. The KEYLESS-GO key must be in the vehicle.
USA only:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
Any unauthorized modification to this device could void the user's authority to operate the equipment.
The product label with FCC ID and IC certification number can be found in the battery case of the SmartKey.
Canada only:
This device complies with RSS-Gen of Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
Any unauthorized modification to this device could void the user's authority to operate the equipment.
The product label with FCC ID and IC certification number can be found in the battery case of the SmartKey.
See also:
Activating with the current or last
stored speed
WARNING
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising from re ...
Restoring the factory settings
- Press the and
buttons
simultaneously for approximately six
seconds until the battery check lamp
flashes twice. ...
Automatic transmission
WARNING
It is dangerous to shift the automatic
transmission out of parking position P or
neutral position N if the engine speed is
higher than idle speed. If your foot is not firmly
on the b ...
