Opening/closing the garage door

Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

ignition lock. Turn the SmartKey to position 2 in the ignition lock.

overhead control panel that you have Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.

Garage door system with a fixed code:

indicator lamp 1 lights up green.

Garage door system with a rolling code:

indicator lamp 1 flashes green.

as long as the transmitter button is being The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.

    See also:

    Activating the rear view camera
    Make sure that the SmartKey is in position 2 in the ignition lock. Engage reverse gear. The area behind the vehicle is shown in the COMAND display with guide lines. ...

    Engine
    Display messages Possible causes/consequences and Solutions The coolant level is too low. – Add coolant, observing the warning notes when doing so. – If coolant needs ...

    Important safety notes
    For reasons of safety, Mercedes-Benz recommends that you drive with the lights switched on even during the daytime. In some countries, operation of the headlamps varies due to legal requirements a ...