Warning and display messages in the multifunction display

Activate ATTENTION ASSIST using the onboard

computer. Activate ATTENTION ASSIST using the onboard computer.

Symbol 1 appears in the multifunction display.

If ATTENTION ASSIST is active, you will be warned no sooner than 20 minutes after your journey has begun. You will then hear an intermittent warning tone twice, and the Attention Assist: Time for a break? message appears in the multifunction display.

Press  to confirm the message. If necessary, take a break.

On long journeys, take regular breaks in good Press On long journeys, take regular breaks in good to confirm the message.

On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.

ATTENTION ASSIST is reset when you continue your journey and starts assessing your tiredness again if:
• you switch off the engine.
• you take off your seat belt and open the driver's door, e.g. for a change of drivers or to take a break.

    See also:

    Restricting the shift range
    - Pull the left-hand steering wheel paddle shifter. The automatic transmission shifts down one gear and restricts the shift range to the relevant gear. If the engine exceeds the maximum ...

    Information about driving abroad
    Converting to symmetrical low beam when driving abroad: switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road to the country where the ...

    Snow chains
    For safety reasons, Mercedes-Benz recommends that you only use snow chains which have been specially approved for your vehicle by Mercedes-Benz, or are of a corresponding standard of quality. ...