Setting the map to the vehicle position, intermediate stop or destination position
Centering the map on the vehicle position
To show the menu: press 
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding 
and turning 
the COMAND controller and press to
confirm.
Select Vehicle Position Map and press
to confirm or, if the crosshair is
shown,
press the 
back button.
This hides the crosshair.
Centering on an intermediate stop
This function requires that a route to an intermediate stop has been calculated.
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller and press to
confirm.
Select Stopover Map and press
to
confirm.
The crosshair is centered on the destination.
Centering on the destination
This function requires that a route to a destination has been calculated.
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller and press to
confirm.
Select Destination Map and press
to
confirm.
The crosshair is centered on the destination.
See also:
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences are ...
Locking the vehicle
If the vehicle can no longer be locked with the
SmartKey, you can lock it by taking the
following steps.
► Close the front-passenger door, the
rear
door on the front-passenger side and the ...
Unlocking the trunk (Sedan)
The trunk lid swings upwards when
opened. Therefore, make sure that there is
sufficient clearance above the trunk lid.
If the trunk cannot be unlocked with the
SmartKey or KEYLESS-GO, use the
...