SmartKey
Display messages | Possible causes/consequences and •► Solutions |
Key Does Not
Belong to Vehicle
You have put the wrong SmartKey in the ignition lock.
•► Use the correct SmartKey.
Take Your Key from
Ignition
The SmartKey is in the ignition lock.
•► Remove the SmartKey.
Obtain a New Key
The SmartKey needs to be replaced.
•► Visit a qualified specialist workshop
Replace Key Battery
The batteries of the KEYLESS-GO key are discharged.
•► Change the batteries
Don't Forget Your
Key
The display message is shown for a maximum of 60 seconds and is only a reminder.
You have opened the driver's door with the engine switched off.
The KEYLESS-GO key is not in the ignition lock.
•► Remember to take the KEYLESS-GO key with you when you leave the vehicle.
Key Not Detected (red display
message)
The KEYLESS-GO key is not in the vehicle.
A warning tone also sounds.
If the engine is switched off, you can no longer lock the vehicle centrally or start the engine.
•► Pull over and stop the vehicle safely as soon as possible, paying attention to road and traffic conditions.
•► Apply the parking brake.
•► Locate the KEYLESS-GO key.
The KEYLESS-GO key is not detected while the engine is running because there is interference from a strong source of radio waves.
A warning tone also sounds.
•► Pull over and stop the vehicle safely as soon as possible, paying attention to road and traffic conditions.
•► Engage the parking brake.
•► Operate the vehicle with the SmartKey in the ignition lock.
Key Not Detected (White
display
message)
The KEYLESS-GO key cannot be detected at present.
•► Change the location of the key with the KEYLESS-GO functions in the vehicle.
If the KEYLESS-GO key is still not detected:
•► Operate the vehicle with the SmartKey in the ignition lock.
Key Detected in
Vehicle
The KEYLESS-GO key has been detected inside the vehicle during locking.
•► Remove the KEYLESS-GO key from the vehicle.
Remove 'Start'
Button and Insert
Key
KEYLESS-GO is temporarily malfunctioning or is defective. A warning tone also sounds.
•► Insert the SmartKey into the ignition lock and turn it to the desired position.
•► Visit a qualified specialist workshop.
Close Doors to
Lock Vehicle
At least one door is open. A warning tone also sounds.
•► Close all doors and lock the vehicle again.
See also:
Checking tire pressure manually
To determine and set the correct tire pressure, proceed as follows:
Remove the valve cap of the tire that is to be checked.
Press the tire pressure gauge securely onto the valve.
Read the tire ...
Changing the picture format
Select Source in the AUX menu and press
the button on the remote control to
confirm.
Select Display Aux or Disk Drive Aux
and press the button to confirm.
Select Auto16:9 optimized, 4:3 o ...
Detaching and storing the cargo net
Detach guide rod 2 from bracket 1 ().
Press the red button on the upper and lower guide rods.
Fold the cargo net and roll it up.
Close the two Velcro fasteners on the cargo net holder.
...