Warning and display messages in the multifunction display

•► Activate ATTENTION ASSIST using the onboard

•► Activate ATTENTION ASSIST using the onboard computer

Symbol 1 appears in the multifunction display.

If ATTENTION ASSIST is active, you will be warned no sooner than 20 minutes after your journey has begun. You will then hear an intermittent warning tone twice, and the Attention Assist: Time for a rest? message appears in the multifunction display.

•► If necessary, take a break.
•► Press On long journeys, take regular breaks in good to confirm the message.

On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.

ATTENTION ASSIST is reset when you continue your journey and starts assessing your tiredness again if:

 - you switch off the engine.
 - you take off your seat belt and open the driver's door, e.g. for a change of drivers or to take a break.

    See also:

    Cup holder in the front-compartment center console
    You can remove the cup holder's rubber mat for cleaning. Clean with clear, lukewarm water only. 1 Cup holders 2 Cover – To open: slide cover 2 fully forwards. ...

    SRS warning lamp
    SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time. The SRS warning lamp in the instrume ...

    Active Blind Spot Assist
    Important safety notes Active Blind Spot Assist uses a radar sensor system to monitor the side areas of your vehicle which are in back of the driver. A warning display in the exterior mirrors d ...