SRS warning lamp
SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time.
The SRS warning lamp in the
instrument
cluster lights up when the ignition is switched
on. It goes out no later than a few seconds
after the engine is started.
The SRS components are in operational
readiness when the SRS warning lamp
is not lit while the engine is running.
WARNING
The SRS self-check has detected a
malfunction if the SRS
warning lamp:
• does not come on at all
• fails to go out approximately 4 seconds after the engine was started
• comes on after the engine was started or while driving
For your safety, Mercedes-Benz strongly
recommends that you have the system
checked as soon as possible at an authorized
Mercedes-Benz Center. Otherwise the SRS
may not be activated when it is needed in an
accident, which could result in serious or fatal
injury. The SRS might also deploy
unexpectedly and unnecessarily which could
also result in injury.
In addition, improper work on the SRS creates
a risk of rendering the SRS inoperative or
causing unintended air bag deployment. Work
on the SRS must therefore only be performed
by qualified technicians. Contact an
authorized Mercedes-Benz Center.
If it is necessary to modify an air bag system
to accommodate a person with disabilities,
contact an authorized Mercedes-Benz Center
for details. USA only: Call our Customer
Assistance Center at 1-800-FOR-MERCedes
(1-800-367-6372) for details.
See also:
Engine number
1. Emission control information plate,
including the certification of both federal
and Californian emissions standards
2. Engine number (stamped into the
crankcase)
3. VIN (on the lower edge ...
Introduction
SRS consists of:
• the SRS warning lamp
• air bags
• air bag control unit (with crash sensors)
• Emergency Tensioning Devices
• belt force limiters
SRS reduces the risk of occupants coming
in ...
Map information in the display
Showing text information
During route guidance, you can have map
information displayed at the bottom edge of
the display.
To show the menu: press
the COMAND
controller.
Select Navi in ...