Fuse box in the engine compartment
Make sure that the windshield wipers are
turned off.
WARNING
Make sure that the windshield wipers are
switched off and that the SmartKey is
removed from the ignition lock before you
open the cover of the fuse box. Otherwise, the
windshield wipers and the wiper rods above
the cover could be set in motion. This could
lead to you or others being injured by the
wiper rods.
Open the hood.

Remove any existing moisture from the
fuse box using a dry cloth.
Take lines 2 from the guides.
To open: open clamps 1.
Remove the fuse box cover forwards.
Make sure that no moisture can
enter the
fuse box when the cover is open.
To close: check whether the rubber seal is
lying correctly in the cover.
Insert the cover at the rear of the fuse box
into the retainer.
Fold down the cover and close clamps 1.
Secure lines 2 in the guides.
The cover must be seated
properly,
otherwise moisture or dirt could impair the
function of the fuses.
Close the hood.
See also:
Engine number
1 Emission control information plate,
including the certification of both federal
and Californian emissions standards
2 Engine number (stamped into the
crankcase)
3 VIN (on the lower edge ...
Useful information
This Operator's Manual describes
all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differenc ...
Please bear the following in mind
The engine oils are matched to the
performance of Mercedes-Benz engines and
service intervals. You should therefore only
use engine oils and oil filters that are
approved for vehicles with mainten ...
