Transfer case
This section is only valid for vehicles with 4- wheel drive (4MATIC). Power is always transmitted to both axles.
Performance tests may only be carried out on a 2-axle dynamometer. The brake system or transfer case could otherwise be damaged. Contact a qualified specialist workshop for a performance test.
Mercedes-Benz recommends that you use an authorized Mercedes-Benz Center for this purpose.
To prevent ESP® from intervening, the ignition must be switched off (SmartKey or the Start/Stop button in position 0 or 1) if:
- the parking brake is being tested on a
brake dynamometer.
- the vehicle is being towed with only one
axle raised (not permitted for vehicles
with 4MATIC).
The brake system could otherwise be damaged.
See also:
Changing gear
The automatic transmission shifts to the
individual gears automatically when it is in
transmission position D. This automatic
gearshifting behavior is determined by:
• a shift range restriction ...
Charging the battery
WARNING
Never charge a battery still installed in the
vehicle unless a battery charger unit approved
by Mercedes-Benz is being used. Gases may
escape during charging and cause explosions
th ...
Load index
In addition to the load bearing index, the load
index may also be imprinted on the sidewall
of the tire. This specifies the load bearing
capacity more precisely. ...
