Where am I?

You can view your current position whether or not route guidance has been interrupted.

1 Current position
2 Next intersection or exit
3 Most recent intersection or exit
4 Current street

To activate navigation mode: press the function button once or twice. function button once or twice.

the COMAND To show the menu: press the COMAND the COMAND controller.

menu bar by turning Select Position in the navigation system menu bar by turning the COMAND the COMAND controller and press Select Where am I? and press to confirm.

to Select Where am I? and press to to confirm.

    See also:

    Checking the oil level using the oil dipstick
    On vehicles with a 12-cylinder engine, the oil level can be checked using the on-board computer. On all other models, the dipstick must be used to check the engine oil level. Example: vehic ...

    Entering characters in the address and the phone book
    Introduction The following section describes how to enter characters in the phone book/address book when creating a new entry. Creating a new entry in the phone book Call up the input menu wit ...

    ATA (Anti-Theft Alarm system)
    alarm system is armed and you open: • a door • the vehicle with the mechanical key • the trunk lid • the hood The alarm is not switched off, even if you close the open door that has tri ...