SmartKey
You have put the wrong SmartKey in the ignition lock. Use the correct SmartKey. |
|
The SmartKey is in the ignition lock. Remove the SmartKey. |
|
The SmartKey needs to be replaced. Visit a qualified specialist workshop. |
|
The batteries of the KEYLESS-GO key are discharged. Change the batteries. |
|
The display message is shown for a maximum of 60 seconds and
is only a reminder. You have opened the driver's door with the engine switched off. The KEYLESS-GO key is not in the ignition lock. Remember to take the KEYLESS-GO key with you when you leave the vehicle. |
|
The KEYLESS-GO key is not in the vehicle. A warning tone also sounds. If the engine is switched off, you can no longer lock the vehicle centrally or start the engine. Pull over and stop the vehicle safely as soon as possible, paying attention to road and traffic conditions. Apply the parking brake. Locate the KEYLESS-GO key. |
|
The KEYLESS-GO key is not detected while the engine is running
because there is interference from a strong source of radio waves. A warning tone also sounds. Pull over and stop the vehicle safely as soon as possible, paying attention to road and traffic conditions. Engage the parking brake. Operate the vehicle with the SmartKey in the ignition lock. |
|
The KEYLESS-GO key cannot be detected at present. Change the location of the key with the KEYLESS-GO functions in the vehicle. If the KEYLESS-GO key is still not detected: Operate the vehicle with the SmartKey in the ignition lock. |
|
The KEYLESS-GO key has been detected inside the vehicle during
locking. Remove the KEYLESS-GO key from the vehicle. |
|
KEYLESS-GO is temporarily malfunctioning or is defective. A
warning tone also sounds. Insert the SmartKey into the ignition lock and turn it to the desired position. Visit a qualified specialist workshop. |
|
At least one door is open. A warning tone also sounds. Close all doors and lock the vehicle again. |
See also:
Removing the ball coupling
Observe the manufacturer's installation instructions.
Press the protective cap into the ball coupling recess.
Make sure that the protective cap is firmly in place.
...
Locking the vehicle
If the vehicle can no longer be locked with the
SmartKey, you can lock it by taking the
following steps.
► Close the front-passenger door, the
rear
door on the front-passenger side and the ...
Overview
The on-board computer is activated as soon
as you turn the SmartKey to position 1 in the
ignition lock.
You can control the multifunction display and
the settings in the on-board computer using ...