Calibrating the compass
Make sure that there is sufficient space for you to drive in a circle without impeding the remaining traffic.
In order to calibrate the compass correctly,
observe the following points:
• calibrate the compass in the open and not
in the vicinity of steel constructions or highvoltage
transmission lines.
• switch off electrical consumers, for
example, the climate control, windshield
wipers or rear window defroster.
• close all doors and the trunk lid.
Switch the ignition on.
Press a round pin into opening 3
for approximately six seconds
until the C symbol appears in compass
display 2.
Drive a full circle at
approximately 3 mph
(5 km/h) to 6 mph (10 km/h).
Once the calibration has been successfully
completed, the current direction appears in
compass display 2.
See also:
Rejects or ends a call
•► Press the button on the
steering
wheel.
If you are not in the Tel menu, you can still
reject or end a call. ...
Monitoring range of the sensors
Blind Spot Assist monitors the area shown in
the figure up to 10 ft (3 m) behind and
immediately adjacent to your vehicle.
WARNING
Blind Spot Assist monitors certain areas in the
im ...
Opening/closing automatically fromthe inside
WARNING
Maintain sight of the area around the rear of
the vehicle while operating the tailgate with
the door-mounted remote tailgate switch.
Monitor the opening procedure carefully to
...