Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
Turn the SmartKey to position 2
in the
ignition lock.
Press transmitter button 2, 3 or 4
in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code: indicator lamp 1 lights up green.
Garage door system with a rolling code: indicator lamp 1 flashes green.
The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.
See also:
Problems with the cooling with air dehumidification function
When you press the button, the indicator
lamp in the button flashes three times or remains off. You can no longer switch
on the cooling with air dehumidification function.
X Consult a qualified ...
Cup holder in the front-compartment
center console
You can remove the cup holder's rubber mat
for cleaning. Clean with clear, lukewarm
water only.
1 Cup holders
2 Cover
– To open: slide cover 2 fully forwards. ...
General information
If you cannot lock or unlock the vehicle with
the SmartKey, either the battery in the
SmartKey is discharged, the SmartKey is
faulty or the starter battery is discharged.
► Check the battery ...