Setting the specified minimum distance
You can set the specified minimum distance for DISTRONIC PLUS by varying the time span between one and two seconds. With this function, you can set the minimum distance that DISTRONIC PLUS keeps to the vehicle in front, dependent on vehicle speed. You can see this distance in the multifunction display.
WARNING
It is up to the driver to exercise discretion to
select the appropriate setting given road
conditions, traffic, driver's preferred driving
style and applicable laws and driving
recommendations for safe following distance.
To increase: turn control
2 in direction 3.
DISTRONIC PLUS then maintains a greater
distance between your vehicle and the
vehicle in front.
To decrease: turn control 2
in direction 1.
DISTRONIC PLUS then maintains a shorter
distance between your vehicle and the
vehicle in front.
Make sure that you maintain a
sufficient
and safe distance from the vehicle in front.
Adjust the distance to the vehicle in front if necessary.
See also:
Activating/deactivating the residualheat function
It is possible to make use of the residual heat
of the engine to continue heating the
stationary vehicle for up to 30 minutes after
the engine has been switched off. The heating
time depends on th ...
Maximum gradient-climbing capability
For good road surface conditions, the
maximum gradient-climbing capability is
100%, which corresponds to an approach/
departure angle of 45°. Note that the
vehicle's gradient-climbing capability
...
Lights
Display messages about LEDs:
This display message will only appear if all LEDs have failed.
Display messages
Cornering Lamp
Left or Cornering
Lamp Right
Possible causes/consequences an ...