Calling up a stored setting
If you want to move the seat
from the fully
reclined position to a stored seat position,
first raise the backrest. The seat could
otherwise be damaged.
Press and hold the relevant
storage
position button 1, 2 or 3 until the seat,
steering wheel and exterior mirrors are in
the stored position.
The setting procedure is
interrupted as
soon as you release the storage position
button.
See also:
Decoupling a trailer
WARNING
While you are coupling or decoupling a trailer,
make sure nobody locks or unlocks the
vehicle and/or opens or closes doors or the
tailgate.
The vehicle's level could change an ...
Cleaning the wiper blades
WARNING
Before cleaning the windshield or wiper
blades, switch off the windshield wipers and
remove the SmartKey from the ignition lock.
On vehicles with KEYLESS-GO, press the
Start/Stop butt ...
Cargo tie-down rings
Observe the following notes on securing loads:
secure the load using the cargo tie down rings.
do not use elastic straps or nets to secure a load, as these are only intended
as an anti-slip p ...