Checking tire pressures manually
To determine and set the correct tire
pressure, proceed as follows:
– Remove the valve cap of the tire that is to
be checked.
– Press the tire pressure gauge securely onto
the valve.
– Read the tire pressure and compare it with
the recommended value on the Tire and
Loading Information placard on the
B-pillar on the driver's side of your vehicle.
– If necessary, increase the tire pressure to
the recommended value.
– If the tire pressure is too high, release air
by pressing down the metal pin in the valve
using the tip of a pen, for example. Then
check the tire pressure again using the tire
pressure gauge.
– Screw the valve cap onto the valve.
– Repeat these steps for the other tires.
See also:
Stowage compartments in the rear
Stowage compartment in the rear
Do not sit or lean your
bodyweight on the
armrests when they are folded out as you
could damage them.
Close the cover of the stowage
compartment before fold ...
General information
Automatic picture shutoff
If the vehicle is traveling faster than
approximately 3 mph (5 km/h) and video
DVD mode is activated, the picture is
deactivated automatically.
The video picture is o ...
Useful information
This Operator's Manual describes all models and all standard and optional equipment
of your vehicle available at the time of publication of the Operator's Manual. Country-specific
diffe ...