Tire pressure of 180 kPa (1.8 bar/ 26 psi) is reached
– Switch off the tire inflation compressor.
– Unscrew the filler hose from the valve of
the faulty tire.
After use, excess TIREFIT may run out of
the filler hose. This could cause stains.
Therefore, place the filler hose in the plastic
bag which contained the TIREFIT kit.
– Stow the tire sealant bottle and the tire
inflation compressor.
– Pull away immediately.
WARNING
Do not exceed a vehicle speed of 50 mph
(80 km/h). A TIREFIT repair is not designed to
operate at higher speeds.
The sticker must be attached on the
instrument cluster where it will be easily seen
by the driver.
Vehicle handling characteristics of a TIREFIT
repaired tire may change. Adapt your driving
accordingly.
– Stop after driving for approximately ten minutes and check the tire pressure with the tire inflation compressor.
WARNING
If tire inflation pressure has fallen below
130 kPa (1.3 bar/26 psi) do not continue to
drive the vehicle.
Park your vehicle safely away from the
roadway and contact the nearest authorized
Mercedes-Benz Center or Roadside
Assistance.
Have the damaged tire replaced.
– Correct the tire pressure if it is at least
130 kPa (1.3 bar/20 psi) (for the required
values, see the Tire and Loading
Information placard on the driver's side
B-pillar or the tire pressure table inside the
fuel filler flap).
– To increase the tire pressure: switch on
the tire inflation compressor.
9 Pressure release button
10 Pressure gauge
– To reduce the tire pressure: press
pressure release button 9 on the filler
hose.
– Stow the tire sealant bottle and the tire
inflation compressor.
– Drive to the nearest workshop and have the
tire changed there.
– Have the tire sealant bottle replaced as
soon as possible at a qualified specialist
workshop, e.g. at an authorized Mercedes-
Benz Center.
Environmental note
Have the used tire sealant bottle disposed of
professionally, e.g. at an authorized
Mercedes-Benz Center.
– Have the tire sealant bottle replaced every four years at a qualified specialist workshop, e.g. an authorized Mercedes- Benz Center.
See also:
High-beam headlamps
► Switch off the lights.
► Open the hood.
► Turn housing cover 1
counter-clockwise
and pull it out.
► Turn bulb holder 2
counter-clockwise and
pull it out.
► ...
Bag hooks
The bag hook can bear a maximum load
of 6.6 lbs (3 kg). Do not use it to secure a
load.
Pull bag hook 2 down by tab 1. ...
The interior: Luxurious surrounds with many exclusive touches
Quite apart from its breathtaking design, the vehicle body of the new
Mercedes CLS spoils all occupants with its generous interior measurements: in
particular, the four-door coupé offers mo ...