Preparing the vehicle
Your vehicle may be equipped with:
- TIREFIT kit
- a "Minispare" emergency spare wheel
- MOExtended tires (tires with run-flat
properties)
Vehicle preparation is not necessary on vehicles with MOExtended tires.
Vehicles equipped with MOExtended tires
are not equipped with a TIREFIT kit at the
factory. It is therefore recommended that
you additionally equip your vehicle with a
TIREFIT kit if you mount tires that do not
feature run-flat properties, e.g. winter tires.
A TIREFIT kit can be obtained from an
authorized Mercedes-Benz Center.
– Make sure that highway level is
selected.
– Stop the vehicle on solid, non-slippery and
level ground, as far away as possible from
traffic.
– Switch on the hazard warning lamps.
– Engage the electric parking brake manually.
– Bring the front wheels into the straightahead
position.
– Move the DIRECT SELECT lever to P.
– Switch off the engine.
– Vehicles without KEYLESS-GO: remove
the SmartKey from the ignition lock.
– Vehicles with KEYLESS-GO: open the
driver's door.
The on-board electronics have status 0,
which is the same as the SmartKey having
been removed.
– Vehicles with KEYLESS-GO: remove the
Start/Stop button from the ignition lock.
– All occupants must get out of the vehicle.
Make sure that they are not endangered as
they do so.
– Make sure that no one is near the danger
area while a wheel is being changed.
Anyone who is not directly assisting in the
wheel change should, for example, stand
behind the barrier.
– Get out of the vehicle. Pay attention to
traffic conditions when doing so.
– Close the driver's door.
– Unload heavy luggage.
Only operate the tire inflation compressor
using a 12 V socket (Y page 297), even if
the ignition is turned off.
An emergency cut-off ensures that the onboard
electrical system voltage does not
drop too low. If the on-board electrical
system voltage is too low, power to the
sockets is automatically cut off. This
ensures that there is sufficient power to
start the engine.
See also:
Displaying details
Select Data/Connections in the
telephone basic menu by sliding and
turning the COMAND controller and
press to confirm.
Select Bluetooth Telephones and press
to confirm.
Select the des ...
Vehicles with a "Minispare" emergencyspare wheel
► Lift the trunk floor up.
1 Alignment bolt
2 Towing eye
3 Lug wrench
4 Ratchet wrench
5 Velcro fastener
6 Jack
7 Wheel bolts
8 Folding wheel chock
9 Fuse allocation chart
10 Stowage ...
Matte finish care
If your vehicle has a clear matte finish,
observe the following instructions in order to
avoid damage to the paintwork due to
incorrect care.
These notes also apply to light alloy wheels
with ...