Automatic car wash

Braking efficiency is reduced after washing WARNING
Braking efficiency is reduced after washing the vehicle. This could cause an accident. For this reason, you must drive particularly carefully after washing the vehicle until the brakes have dried.

You can wash the vehicle in an automatic car wash from the very start.

Never clean your vehicle in a Touchless Never clean your vehicle in a Touchless Automatic Car Wash as these use special cleaning agents. These cleaning agents can damage the paintwork or plastic parts.

If the vehicle is very dirty, pre-wash it before cleaning it in an automatic car wash.

In car washes with a towing mechanism, In car washes with a towing mechanism, make sure that the automatic transmission is in transmission position N, otherwise the vehicle could be damaged.
- Vehicles with a SmartKey:
Do not remove the SmartKey from the ignition lock. Do not open the driver's door or front-passenger door when the engine is switched off. Otherwise, the automatic transmission selects park position P automatically and locks the wheels. You can prevent this by shifting the automatic transmission to N beforehand.
- Vehicles with KEYLESS-GO:
Do not open the driver's door or frontpassenger door when the engine is switched off. Otherwise, the automatic transmission selects park position P automatically and locks the wheels.

Observe the following to make sure that the automatic transmission stays in position N:
– Make sure the vehicle is stationary and the ignition is switched off.
– Turn the SmartKey to position 2 (Y page 139) in the ignition lock.
Use the SmartKey instead of the Start/Stop button on vehicles with KEYLESS-GO.
– Depress and hold the brake pedal.
– Shift the automatic transmission to position N.
– Release the brake pedal.
– Release the electric parking brake.
– Switch off the ignition and leave the SmartKey in the ignition lock.

Make sure that: Make sure that:
- the side windows and the sliding sunroof are fully closed.
- the ventilation/heating is switched off (the OFF button has been pressed).
- the windshield wiper switch is in position 0.
Otherwise, the vehicle might be damaged.

After using an automatic car wash, wipe off wax from the windshield and the wiper blades. This will prevent smears and reduce wiping noises caused by residue on the windshield.

    See also:

    Activation conditions
    You can activate the HOLD function if:  - the vehicle is stationary.  - the engine is running.  - the driver's door is closed or your seat belt is fastened.  - the p ...

    Sport Utility Vehicle
    WARNING   This Sport Utility Vehicle is designed for both on-road and off-road use. It can go places and perform tasks for which conventional 2-wheel drive passenger cars are not intende ...

    Problems with fuel and the fuel tank
    ...