Checking the coolant level

Only check the coolant level when the vehicle is on a level surface and the engine has cooled down.
– Turn the SmartKey to position 2 (Y page 139) in the ignition lock.
On vehicles with KEYLESS-GO, press the Start/Stop button twice.
– Check the coolant temperature gauge in the multifunction display.
The coolant temperature must be below 158 °F (70 °C).

In order to avoid any potentially serious burns: WARNING
In order to avoid any potentially serious burns:
- use extreme caution when opening the hood if there are any signs of steam or coolant leaking from the cooling system, or if the coolant temperature display indicates that the coolant is overheated.
- do not remove the pressure cap on the coolant reservoir if the coolant temperature is above 158 °F (70 °C). Allow the engine to cool down before removing the cap. The coolant reservoir contains hot fluid and is under pressure.
- using a rag, slowly turn the cap approximately 1/2 turn to relieve excess pressure. If opened immediately, scalding hot fluid and steam will be blown out under pressure.
- do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which may burn if it comes into contact with hot engine parts.

– Slowly turn cap 1 half a turn counterclockwise

– Slowly turn cap 1 half a turn counterclockwise and allow excess pressure to escape.
– Turn cap 1 further counter-clockwise and remove it.
If the coolant is at the level of marker bar 3 in the filler neck when cold, there is enough coolant in coolant expansion tank 2.
If the coolant is approximately 0.6 in (1.5 cm) above marker bar 3 in the filler neck when warm, there is enough coolant in coolant expansion tank 2.
– If necessary, add coolant that has been tested and approved by Mercedes-Benz.
– Replace cap 1 and turn it clockwise as far as it will go.

    See also:

    Hazard warning lamps
    The hazard warning lamps automatically switch on if: • an air bag is deployed. • the vehicle is slowed down severely from a speed of over 45 mph(70 km/h) and comes to a halt. ► To swit ...

    4MATIC (permanent four-wheel drive)
    4MATIC ensures that all four wheels are permanently driven. Together with ESP® and ETS, it improves the traction of your vehicle whenever a drive wheel spins due to insufficient grip. WARNIN ...

    Opening and closing
    You can continue to operate the sliding sunroof after switching off the engine or removing the SmartKey from the ignition lock. This function is available for up to five minutes or until th ...